ELISA Kit for Aconitase 1 (ACO1)

IREB1; IRP1; IREBP; Iron regulatory protein 1; Iron-responsive element-binding protein 1; Cytoplasmic aconitate hydratase; Citrate hydro-lyase; Ferritin repressor protein

  • ELISA Kit for Aconitase 1 (ACO1) Packages (Simulation)
  • ELISA Kit for Aconitase 1 (ACO1) Packages (Simulation)
  • ELISA Kit for Aconitase 1 (ACO1) Results demonstration
  • SEJ683Hu.jpg Typical Standard Curve
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Specificity of the ELISA Kit for Aconitase 1 (ACO1)

This assay has high sensitivity and excellent specificity for detection of Aconitase 1 (ACO1).
No significant cross-reactivity or interference between Aconitase 1 (ACO1) and analogues was observed.

Recovery of the ELISA Kit for Aconitase 1 (ACO1)

Matrices listed below were spiked with certain level of recombinant Aconitase 1 (ACO1) and the recovery rates were calculated by comparing the measured value to the expected amount of Aconitase 1 (ACO1) in samples.

Matrix Recovery range (%) Average(%)
serum(n=5) 95-103 99
EDTA plasma(n=5) 89-96 93
heparin plasma(n=5) 79-102 96

Precision of the ELISA Kit for Aconitase 1 (ACO1)

Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Aconitase 1 (ACO1) were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Aconitase 1 (ACO1) were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Linearity of the ELISA Kit for Aconitase 1 (ACO1)

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Aconitase 1 (ACO1) and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample 1:2 1:4 1:8 1:16
serum(n=5) 78-93% 97-105% 84-105% 96-105%
EDTA plasma(n=5) 93-104% 95-102% 86-95% 78-101%
heparin plasma(n=5) 78-89% 91-98% 90-99% 81-91%

Stability of the ELISA Kit for Aconitase 1 (ACO1)

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5% within the expiration date under appropriate storage condition.
To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay procedure summary of the ELISA Kit for Aconitase 1 (ACO1)

1. Prepare all reagents, samples and standards;
2. Add 100µL standard or sample to each well. Incubate 1 hours at 37°C;
3. Aspirate and add 100µL prepared Detection Reagent A. Incubate 1 hour at 37°C;
4. Aspirate and wash 3 times;
5. Add 100µL prepared Detection Reagent B. Incubate 30 minutes at 37°C;
6. Aspirate and wash 5 times;
7. Add 90µL Substrate Solution. Incubate 10-20 minutes at 37°C;
8. Add 50µL Stop Solution. Read at 450nm immediately.

Test principle of the ELISA Kit for Aconitase 1 (ACO1)

The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Aconitase 1 (ACO1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Aconitase 1 (ACO1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Aconitase 1 (ACO1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Aconitase 1 (ACO1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Related products

Catalog No. Organism species: Homo sapiens (Human) Applications (RESEARCH USE ONLY!)
RPJ683Hu02 Recombinant Aconitase 1 (ACO1) Positive Control; Immunogen; SDS-PAGE; WB.
RPJ683Hu03 Recombinant Aconitase 1 (ACO1) Positive Control; Immunogen; SDS-PAGE; WB.
RPJ683Hu04 Recombinant Aconitase 1 (ACO1) Positive Control; Immunogen; SDS-PAGE; WB.
RPJ683Hu01 Recombinant Aconitase 1 (ACO1) Positive Control; Immunogen; SDS-PAGE; WB.
PAJ683Hu04 Polyclonal Antibody to Aconitase 1 (ACO1) WB; ICC; IHC-P; IHC-F; ELISA.
PAJ683Hu02 Polyclonal Antibody to Aconitase 1 (ACO1) WB; ICC; IHC-P; IHC-F; ELISA.
PAJ683Hu01 Polyclonal Antibody to Aconitase 1 (ACO1) WB; ICC; IHC-P; IHC-F; ELISA.
PAJ683Hu03 Polyclonal Antibody to Aconitase 1 (ACO1) WB; IHC; ICC; IP.
LAJ683Hu71 Biotin-Linked Polyclonal Antibody to Aconitase 1 (ACO1) WB; IHC; ICC.
SEJ683Hu ELISA Kit for Aconitase 1 (ACO1) Enzyme-linked immunosorbent assay for Antigen Detection.
LMJ683Hu Multiplex Assay Kit for Aconitase 1 (ACO1) ,etc. by FLIA (Flow Luminescence Immunoassay) FLIA Kit for Antigen Detection.
GUESTBOOK